Comgrow Laser Enclosure Fan Adapter
Description
So I already made the "Duct Flange 120mm & 3in" model to go on my exhaust fan for my hosing that leads to my window for my last set up. I got a new enclosure [Comgrow] for my new setup, but not only is the exhaust tube much bigger than my hosing, but the mounting on the enclosure [for the fan] is smaller (100mm i think). To avoid adding new holes in the enclosure for my fan (which would be the easiest route) I figured I would just remix the exhaust side duct to something for the induction side of the fan I could slide right over top of the exit tube that come with the enclosure. This would also make it easier for me to slide it off if I need to move the enclosure and not worry about unscrewing anything from the actual enclosure. *THE WHITE PART IN THE PICTURES IS THIS REMIXED OBJECT The black adapter on the opposite side of the fan is the original object and the other black part going in to this white adapter is the part that comes with the Comgrow enclosure. PLA, NO SUPPORT, .03 Layer Height, 20% Infill (was what I did)
Statistics
Likes
0
Downloads
0