Office Space Initech Sculpture
Description
This is the sculpture in front of the Initech office building. Measurements were taken from the screenshot (3rd picture). Designed in Onshape. I also designed the Initech cubes, see https://www.thingiverse.com/thing:5484656 Printed 70% scale on Ender 3V2 with Geeetech Silk Silver PLA at normal print speed (50mm/s), brim, 0.12mm layer height, adaptive layers, Top/Bottom Pattern=concentric, 5% gyroid infill. This filament is stunning and prints fine with normal PLA settings. Print tips Cura: Use the following settings to make the seams on the back of the rod and the bottom of the disk. Set the z-seam alignment to 'User Specified', Z Seam position=back, Seam corner preference=smart hiding. Assembly tips There is a tiny hole in the parts to align them. Heat a standard pin in a flame and push it in both holes to clear. Then cut the pin in half, one side of the pin goes into each piece. Use a drop of super glue and push the pieces together making sure that they are parallel. You could use the edge of a table and small stack of paper under the rod to hold it parallel as they are glued together. "Soooo, ask yourself, is everything I do, good for the company?"
Statistics
Likes
0
Downloads
0