Nanoleaf Panels Triangle Mount
Description
This is a pretty small and decent wall and or sealing mount for nanoleaf light panels. It is not suposed to hold the whjole panel, i just used it to hold down the edges, since the tape there always loosened. It has a hole for a nail which is 1.5 mm in diameter and has a head diameter of about 3.5 mm. The nail is 20 mm long. I had issues with the first layer sticking to the bed, which i could get rid of by reducing the printing speed to about 70 % and after a few layers i set it up to 100 %. This is printed in white PLA, and it is a bit undersized to freely fit in between the panels. If this does not suit you, scale it up to about 105 % - 110 %.
Statistics
Likes
0
Downloads
0