Anycubic Photon D2 Drip Hanger
Description
I was going to remix this (https://www.thingiverse.com/thing:5334012)* model, but couldn't satisfactorily find angles and dimensions that met the following criteria: clear the hanger while on the gantry cleared the gantry while on the hanger drip into the resin vat while on the hanger not exist inside the resin vat (a previous iteration/idea did) not require complete removal to level the build plate. I believe this model meets those requirements. I found having the hanger at a 44 degree angle (from horizontal) was the best for me, but I've also included hangers from 40-45 degrees in 1 degree increments. PRINTING: HANGER_MOUNT: notches for the lead screw facing the build plate HANGER_FINGER: flat side with the holes facing the build plate. obviously you'll need some support. you can probably get away with touching build plate only. B.o.M: 2x 4x5mm M3 heat inserts 2x 12mm M3 SHCS (10mm might also work) 2x M3 Washer (optional) INSTALLATION: Install heat inserts into the hanger mount Remove the build-plate, and tightening bolt completely Push the hanger mount on until it sits flush with the lead screw. Screw the hanger into the hanger mount USE: Build plate slips in using a friction fit For re-leveling the build plate, you can remove one of the bolts (i found the rear one works best) and tilt the hanger finger upwards. You should then have plenty of access to the leveling screws. * thingiverse is basically a lost cause at this point. it wont let me tag this as a remix. i've also uploaded this to printables: https://www.printables.com/model/342233-anycubic-photon-d2-drip-hanger
Statistics
Likes
0
Downloads
0