Aeron Hip Pivot Bolt
Description
Aeron Hip Pivot Bolt is the only real issue I have with Herman Miller Aeron chair. In past 14 years about 8 of them broke on me. Actually the "bolt" itself is ok but the casing for the bolt that is made out of some unknown material (looks like bakelite to me). The chair comes with 12 year warantee so they replace the bolts but it takes time, after 12 years when they brake you can get new ones for 25-50$ but again, it takes time to ship them, especially if you are not in the USA. So what can you do but print a replacement. IMHO this is only TEMPORARY replacement, I'm right now testing the PLA printed one and, well, it works for few hours so far :D maybe it will work long enough till the new replacement part arrives, if not, I can print one every day till the replacement part arrives it's a 10g part easy and quick to print. I made two objects - Hip Pivot Bolt.stl : this part is very hard to use, it is most similar to original but in order to push metal part of the bolt (that you have from the broken original) in to the plastic you have to heat up the part with external heat source. Maybe if you print it with nylon it will be elastic enough so you can push the bolt in to it with some force (I tried pushing just mechanically in to PLA and was not successful but when you heat it up it goes in) - Hip Pivot Bolt - EasyPush.stl : this part is ideal, made out of PLA the bolt will snap in place. The front "enclosure" of the bolt is not important for the functioning of the part so this is easy to print and easy to install There are no "clips" to hold the part in place but these clips are just for ease of installation and are one of the main reasons these parts fail (they always break exactly on clips) I printed in PLA, 0.2mm layer, 10C hotter than normal (to increase strength), 10% higher infill rate (110%), with max perimeters (so the whole part is printed with perimeters) PA would maybe be a better choice, PA filled with CF might be ideal, dunno
Statistics
Likes
0
Downloads
0