Caddx Walnut 30 deg mount for TBS Source1 V5
Description
30deg CADDX Walnut mount for TBS Source1 V5 insert cam from the rear - it's a bit fiddly but goes. BEC wire routing through top plate to side of MAG BEC. I also included a TPU cover for the FC BEC which helps to keep them from separating in a smash. The model titled 'vert' should allow for the cam to be mounted at 90deg for vertical footage. (untested) TPU .3mm layer height, 15% infill. full supports. can supply S3D gcode if your supps are hard to remove.
Statistics
Likes
0
Downloads
4