Zip tie cabel holder for Orbiter hotend on Ender 3 and Hero Me Gen 6 (HGM)
Description
Hi! I made a small zip tie terminal to my Ender 3 Pro's factory X car, upgraded by a Hero Me Gen 6 extruder. This designed to place between the extruder's motor, and the bearing's screws. There is a small hole in the side fix your cabels from the back. It's important to receive less stress in your cabels because there own weight, while make possible to go higher Z level again. With my setup I can go up to 220mm safely, even with this direct drive setup. Happy printing!
Statistics
Likes
0
Downloads
0