Kobra Go Z-axis Support
Description
This is a simple z-axis support for the Anycubic Kobra Go printer. It uses a standard roller skate bearing (22mm diam) and a 2 inch #8-32 screw and nut (or equivalent, you can even use a zip tie). The bearing is a tight fit so I recommend pushing it in while the print is still warm. To install, you just need to remove the top cross support and slide this onto the leadscrew and vertical support. Replace the top support, adjust position and secure in place. I added an small hole to allow an easy place to add on an accessory like a filament guide.
Statistics
Likes
0
Downloads
0