Silhouette Cameo 4 Tool box
Description
I wanted a toolbox that stores inside the cameo when it's not in use, so I used the "Parametric Box for Everything" tool by FMMT666 to create this. It just barely fits inside while still allowing the lid to slide into place. I also sized the interior to fit this front roller bridge design by zumselman: https://www.thingiverse.com/thing:4888781 A small test print STL is included to make sure you get your 3d printer settings right. You need to be able to fit a piece of filament into the hinge hole. I used a piece of flexible filament which gives the lid a bit of a springiness that helps hold the lid open or closed. The magnets I used are 8mm x 2mm round neodymium. I placed two per square hole with a dab of super glue. The holding force isn't amazing since the magnets are edge-to-edge instead of face-to-face but it does the job. Make sure you triple-check your polarity before gluing! Here's a link to the exact magnets I used: https://www.amazon.com/b?node=20547412011/B08C4SQSM3 I'm planning on designing some slide-in blade holders but for now, this helps keep my desk organized, and makes misplacing my tools less likely.
Statistics
Likes
0
Downloads
0