Fan-Duct
Description
I designed this fan duct for a 2nd component fan (4010) on the Ender6 LC with Bondtech extruder. It should be a narrow component, so that the pressure range is not unnecessarily reduced. It can be printed upright without support. For better stability, however, I recommend printing lying down and possibly using a few small supports in the slicer so that the mounting arm is printed lengthwise. It is attached to the base plate at the bottom and fixed at the top with a M4x8 screw. The duct can be adjusted as desired. For this I have included Fusion360, .3mf, .IGES and STEP files. The ZIP of the Inventor files did not want Thinglverse. ******************************************************* Diesen Lüfterkanal habe ich für einen 2ten Bauteillüfter (4010) am Ender6 LC mit Bondtech Extruder konstruiert. Es sollte ein schmales Bauteil werden, damit der Druckbereich nicht unnötig reduziert wird. Es kann ohne Support aufrecht gedruckt werden. Zur besseren Stabilität empfehle ich aber liegend zu drucken und eventuell wenige kleine Stützen im Slicer zu verwenden, damit der Befestigungsarm längs gedruckt wird. Er wird an der Grundplatte unten eingehängt und oben mit einer M4x8 Schraube befestigt. Der Duct kann nach Belieben angepaßt werden. Dazu habe ich Fusion360, .3mf, .IGES und STEP-Dateien beigelegt. Das ZIP der Inventor Dateien wollte Thinglverse nicht.
Statistics
Likes
0
Downloads
0