Joycon Case
Description
I was doing some reading and have done some revisions and have not attempted a print as of this posting but am hoping to do so soon. My anticipation is printing the lid at 100% infill since it will be the primary source of holding the joycons. when it comes to the actual case, im not sure what to entirely print it in. im going to try starting out with just 10% infill. as for the clips they will need to be glued somehow to the bottom case. i would imagine that there will be little to no needed supports. the clips themselves i am going to print them to the max due to the fact that will need to be strong for the durability make sure that you print 2 set of springs. one for each side. the springs themselves came from https://www.thingiverse.com/thing:69518
Statistics
Likes
0
Downloads
0