DJI Action 2 mount
Description
I love the principle of the standard easy click-on mount that comes with the Action2. One can never have enough of these mounts to leave them attached to where you need them and just click-on the camera. But I could only find simpler versions of this mount without the claws or caged mounts. This mount includes magnets and mini-claws to click-on your DJI Action2. It has only three parts and should be easy to assemble. You require addtionally to the printed parts: - Spring with diameter of around 4 mm (eg. from ball pen) - 1mm diameter steel wire (eg. drillbit or nail) - 6 x 3 mm (diameter x height) neodym magnets You can modify the fusion 360 file to create your own version. I marked the important parameters so you can easily change parameters for the spring or the magnets and the width of the base. (see picture) To increase the magnetic effect I stacked two 6x3 magnets on each side. I should say that while the mount does secure the camera quite well, it is not as strong as with the DJI mount with aluminium claws. How strongly this mount can hold on to the camera depends a lot on the stiffness/compression of the springs. Ball-pen springs are normally comparatively weak. You should get stronger springs from your hardware store if the grip is too weak.
Statistics
Likes
0
Downloads
0