CR-10 Max PSU fan shroud
Description
Fan shroud for the PSU unit on the CR-10 Max. Model is done to minimise the material used, thus the wall is thin. I printed it with 0.6mm nozzle with 0.8mm line width (the wall thickness) and 0.3mm layer height. you can use a 0.4mm and push the line width to 0.8mm I managed to reuse the original screws but it is "tight" you might want to lower the model so its sitting -1mm bellow print surface for higher screw thread engagement.
Statistics
Likes
0
Downloads
0