Apple Dock iPhone 14 Pro and Watch (deleted AirPods)
Description
This was always my favorite dock that I could find as it's simple and has great curves/lines. I recently upgraded to an iPhone 14 Pro with an Otterbox case (after breaking my last phone with cheap plastic case) so I remixed this great design in Fusion 360 to work for my current setup. - removed airpods as I don't own them - thickened the base for stability - widened the wire channels on the base and straightened them (my cables were too fat to fit the original channels, could have been my print settings too) - widened camera cutout to allow iPhone 14 Pro to sit flush with stand - removed trough in stand base to slightly raise iPhone to exact center of magsafe (again, this is for my iPhone 14 pro with otterbox case) Print time with 30% triangle infill, 2mm walls/top/bottom, and no supports was just under 15 hours on Longer LK5 Pro and PLA.
Statistics
Likes
0
Downloads
0