Neopixel Shroud for EVA 3
Description
This is a simple remix of the EVA 3 small shroud with the small addition of a wider chin with a simple opening for a single NeoPixel to light up the hotend. I was in a need for some light quickly, so theres not a mechanism in place to hold the NeoPixel yet. I simply glued mine in. I will improve on this when I have some time. I am using an [Adafruit SK6812 NeoPixel](https://www.filastruder.com/collections/electronics/products/adafruit-neopixel) Below is a sample klipper config to enable the NeoPixel on full time: [neopixel hotend_rgb] pin: PA3 # The pin connected to the neopixel. This parameter must be # provided. #chain_count: # The number of Neopixel chips that are "daisy chained" to the # provided pin. The default is 1 (which indicates only a single # Neopixel is connected to the pin). color_order: GRBW # Set the pixel order required by the LED hardware. Options are GRB, # RGB, GRBW, or RGBW. The default is GRB. #initial_RED: 0.0 #initial_GREEN: 0.0 #initial_BLUE: 0.0 initial_WHITE: 1.0 # Sets the initial LED color of the Neopixel. Each value should be # between 0.0 and 1.0. The WHITE option is only available on RGBW # LEDs. The default for each color is 0.
Statistics
Likes
0
Downloads
0