Chungus 9000 Flashlight
Description
Parts list: Light: https://a.co/d/01LI7B0 Battery: https://a.co/d/4zp4IGY Charger: https://a.co/d/1QduqFL Charger adapter: https://a.co/d/82MU7LK Wire: https://a.co/d/0PSASFN Connector: https://a.co/d/iRTLqkK Alarm: https://www.amazon.com/dp/B00XQ91ECA?psc=1&ref=ppx_yo2ov_dt_b_product_details Disclaimer: If improperly cared for, LiPo packs can be dangerous. Please use safe storing and charging practices. The included diagram is for reference only. If you do not have knowledge of wiring electronics, do not attempt. Notes: The spacer should be installed into the bulb housing first, then the headlight. I strongly recommend using a connector for your ground wire so it's easy to remove/replace the headlight in the future. Positive cables for the High and Low beams should be spliced onto spade terminals to connect to the switch. Running lights/turn signals are not used and can be cut short. On a full charge, you should get 2+ hours of continuous use with the high beams. I recommend having the alarm set to 3.5 volts. This will prevent over-discharging the LiPo pack. I cut the plug off of the headlight for my installation and soldered new connectors on, but spade connectors and easily be used to connect to the factory plug.
Statistics
Likes
0
Downloads
0