E3D V6 Shim Set
Description
Here Is A Set Of Spacer Shims Ranging From .25Mm To .50Mm In .05Mm Steps. Their Diameter Is Set So They Will Easily Drop Into The Recess In The Bottom Of A Wades Reloaded Extruder Designed For A Hexagon Hot End. When I Was Fitting My New E3D V6 Hot Ends To My Existing Wades Reloaded Extruders From My Taz 5, I Found That The Top Head On The Hexagon It Was Replacing Was A Bit Higher Than The E3D Head Relative To The Aluminum Plate. I Also Found That One Of My Two Extruders Had A Bit More Gap Than The Other. So, I Designed And Printed These To Solve The Problem. Yea, I Could Just Print Another Extruder Body Specifically For The E3D, But These Are So Much More Simple And Less Waste And Leaves The Extruder Body Able To Take Either A Hex Or E3D Hot End.
Statistics
Likes
21
Downloads
0