CR-10 V3 (M4 nut optimized) - Ultimate Leveling Knob Attachment
Description
My CR-10 doesn't come with the smaller knobs that many are press fitting into these larger knobs. Honestly, the original knobs that come with the printer aren't all that bad but i really like this design. it gives you about 10mm more diameter and i personally think it has better grip. All i did was fill the hole and raise the center portion 2mm to allow less friction against the plate. then i gave it a spot to drop an m4 nut. glue it in to make sure it stays. i bet a Teflon washer would even be a nice addition.
Statistics
Likes
0
Downloads
0