T Track Vise (Vice)
Description
This vise is designed for use with the Aluminum & MDF Hybrid Spoilboard for the PROVerXL, T-Track Grid Table To use you will need: 4 x 20mm M5 bolts 4 x washer for M5 bolts 4 x M5 T Slot nut 2 x 30mm M5 bolts 2 x M5 Square nuts Non slip tape To print a complete setup you need to print: 4 x Short T Clamp 1 x TClamp Part 1 2 x TClamp Part 2 To assemble: Place T Slot nuts in the bottom of the short T Clamps. Using a 20mm M5 nut, washer feed them through the outer gaps in Vise part 2 and screw into the short T Clamps Drop the square nuts into the vise part 2 and screw in the 30mm M5 nuts Add non stick tape to the side facing the work piece on part 1 and one of the part 2's, this will help secure the workpiece and stop it moving. To use: Take one of the part 2 vise and secure it in a t track, place work material and add vise part 1 so that it abuts the work piece. Add the second part 2 vise and secure within the T track Tighten the 2 30mm M5 bolts so that they secure the work piece.
Statistics
Likes
0
Downloads
0