Ultimate CR10S brace and All in One
Description
The pictures will let you know most about what you need and quantity to print the parts. You need a: -25" x 25" plywood board that's at least a half inch thick for the base. -7 rods that are M10 in diameter. -lots of wood screws to secure the parts to the board, dont overtighten because it'll crack the pieces. -bolts and nuts to secure the rod ends. -washers -A metric allen head bolt and nut kit with M8 etc bolts and nuts off amazon -The wire CR10 harness extension you can buy on Amazon -wire to extend from the new power switch location etc -3M super 33 electrical tape -A wire connector kit you can kit on amazon -Hack saw to trim rod if you need help message me off fb through Matts Custom Signs
Statistics
Likes
0
Downloads
0