Micro Swiss NG CR10 Fan Shroud
Description
Took Micro Swiss their shroud model and modified it a little bit. This was more of a quick hack, then a perfect remake of the shroud so keep that in mind... Changes I made to the shroud: - Modified fan port to fit the nozzle of the 5015 instead of the small 4010. - Added devider to the new port to distribute the air more evenly across both ends. - Lowered the 40mm hotend fan a touch so it fits underneath the stepper. - Reinforced the passing duct underneath the 40mm fan because of the lowering - added small nut recess for the 5015 screws Prints fairly easy because the port and divider are at an angle. Minor overhang should print just fine. STP file is included. Hopefully I saved someone else the trouble.
Statistics
Likes
0
Downloads
0