Fun Duct for Flying Bear Reborn 2
Description
I found problems with stability of the filament flow on my Flying Bear Reborn 2, espetially on flex filaments. This fan duct redirects air flow to radiator. I have printed with PETG, 0.4 nozzle, 0.2 layer height No extra hardware needed - just use the same screws for extruder fan. Also I recommend next actions with hotend: 1. Polish inside surface of the nozzle throat 2. Put some heat conductive paste on copper part of the nozzle throat After that quality of my prints with flex filaments is more stable.
Statistics
Likes
0
Downloads
0