G36 rail w/ Peq box
Description
I made this in conjunction with my airsoft Peq battery box. I borrowed from Ohman74's IMF K Airsoft G36 Handguard, and his G36C "Spuhr R22"-like rail. Props to him. I only heavily modified his designs to make a more MG36 rail that I can run a battery on. The rear cap is held on by M3 screws, 10mm and 20mm length but other lengths may be used. I also used several flat top M3 screws with nuts to combine the front and rear half. I put small amounts of JB Weld between the half's which may not be necessary. There are cable routing hooks on the inside of the hand guard to run wires back to the gear box. You will need to create a wiring harness which isn't hard. I can upload pictures on request. The front section has a notch for G36 airsoft bipods.
Statistics
Likes
0
Downloads
1