CR10S Pro V2 Direct Drive
Description
A simple direct drive attachment that doesn't require any additional screws or hardware, it uses the original motor and extruder assembly of the printer. You will need an extension cable for the extruder stepper motor and another for the filament sensor. First assemble the extruder assembly onto the part, then screw the part over the fan shroud using the already existing screws (Pictures for clarification) The print size is not effected and so no firmware changes are needed (but if you want to print the full 400mm z height, the filament sensor should not be mounted on the printer frame).
Statistics
Likes
0
Downloads
0