Flashpup barrel band
Description
This barrel band works excellent for the Flashpup. It not only helps quiet it down, it does an incredible job of locking down the shroud solid making it even more accurate than it was before. The design of the gun only has 2 support points further back which allows a lot of movement at the end of the barrel. This band prevents any movement or vibration. I tried a few other designs that weren't clamped and they ended up rotating and causing errant shots. This one clamps to the shroud at the at the point where the barrel nut is, and the cap over the air cylinder prevents it from moving entirely and still allows room for the fill probe. To install it, you need to remove the shroud which is very simple. Lots of videos out there on how to do that. Install it over the air cylinder cap first and slide the shroud back on through the upper hole. 2 x M3x16mm cap screws and nuts required.
Statistics
Likes
0
Downloads
0