E3P Feet 9.5mm
Description
I remixed the rubber feet by C3D_Miguel, got rid of the slits in the v-slots, closed up the hole, and shortened the over all height. I have a newer E3Pro with the slim rubber feet. I was able to peal off the rubber pads and reuse portions that still had good glue to stick to the bottom of the ones I made, and cut them to length as needed. To install them you would simply pull the end caps and slide them in. These work well if you don't move the printer a lot like me, but if you're always moving it around, they will slide. I'm working on another version that has the end cap as part of the foot so it won't move at all. The design is finished, I just haven't had time to print them and test the fit.
Statistics
Likes
0
Downloads
0