Estes Omega, Cine-Roc, and Astro-Cam goodies
Description
Various goodies to clone an old Estes Omega with a Cine-Roc PNC that takes the new Estes Astro-Cam thumb-cam. The one-piece version of the PNC that I don't care so much for it for it since I have to print it with supports and it tends to come out rough. The three-piece version is better and should be printed without supports. The middle section is set up to print upside-down. Flip it over so that the camera points down and glue the ends on. Both versions of the PNC get a #4 eye-screw at the top to attach the recovery system. The Astro-Cam is held in place by a couple of little pigtail or ponytail rubber bands. Also included in this set is a DXF file to laser-cut the Omega fins from 1/8" balsa.
Statistics
Likes
0
Downloads
0