Microphone Bar Mount
Description
This is a microphone mount that is made to mount to a 30mm vertical bar. More specifically i made it to mount to my dual monitor stand. The stand for my PC microphone is too tall and sits in between my monitors and blocks the time and date in the one corner so i designed this to sit on the pole that my dual monitor mount has and be able to mount it lower than the 3 leg stand that the mic comes with. It requires 4 #8 nuts and 4 1'' long, 1/8'' machine screws. There is also a cable management clip on the side of the mount! Will need to print with supports touching build plate. Most likely 0.2 layer height and temp based on the filament you are using. Most likely best if you use a brim because of the back part of the bar mount. After i print and test i will post the files as a 2 piece design as well so that the back or the bar mount piece can be printed with a brim separately because if you are printing just the front arm piece with supports you shouldn't need a brim or raft depending on your bed adhesion.
Statistics
Likes
0
Downloads
0