JG BAR10 TDC Guide
Description
This is TDC drilling guide for JG BAR10 compatible with stock hop-up chamber. The change was to enlarge depth of original guide from 17mm to 24mm Quoted from the original part: "The hole is made for a M4 screw, which also means that you need a 4mm drill to make the hole. The BARREL mark should be facing the way the inner-barrsel travels thru the outer barrel. do NOT place the BARREL marking towads the cylinder When you drill, please do keep the guider in place with your thumb (like in my picture) or fingers, but be careful to not hurt them. ;) This tools is published as is. I can not be held responsible for any faulty installation or modification of your gun, neither any injuries while using this tool."
Statistics
Likes
0
Downloads
0