Lanard Shellshock x-6 Improved Shells
Description
Original design by ExoticVoid coems out a little thin on the outer diameter, and a too tall on the height of the divot, both were causing feeding issues bad enough to forcibly eject the magazine in my shellshock. I had previously spent a few days designing a shell for it, before realizing there was this design available, and that original design shared part of EV's flaws. I've refined my design using EV's as inspiration, and have made a fully functional shell for half length/short/stefan darts and original lanard darts, and an expiremental shell that technically can fit full length darts and will fit in the magazine. The HO file, Half Only, works very well, and I'm 90% sure the issues with feeding from the magazine that remain are the fault of my poor performing magazine, not the shells themselves. The FC file is different in its internal diameter (12.8mm vs 13mm), how deep the barrel inside goes (all the portion that isnt barrel is only the bottom 0.6mm), and the depth of the rear divot. (it is less deep). This is all changed to accommodate full length darts in the magazine, but ends up causing a lot of friction on that expanded divot. with a smaller diameter printer nozzle, it might be possible to print that wall thinner. Additionally, the FC file is really only recommended for worn out darts, or for a shellshock with an upgraded spring. Marked as WIP for the FC files, but also because I still need to tinker with the depth of the divot on the HO files to see if that will aid in their feeding from the magazine
Statistics
Likes
0
Downloads
0