GE Microwave Drive Cog
Description
I had a plate that didn't fit my GE microwave cog. The slim spindle by Usuariu probably would have worked if it was 4MM taller. However I took the opportunity to make the drive cogs bigger too. This is for using with a plate having approximately 18mm hole in the center of the drive lugs. Attaching to a GE Microwave that normally uses a WB39X10032 plate. Work in progress, untested. I would print at 0.12mm layer height 4 walls and 60% infill Flip it upside down in your slicer to print it standing on its "head"
Statistics
Likes
0
Downloads
0