3DO Controller Port Cover
Description
This is just a simple port cover for 3DO controllers to replace the original plugs that are so easily lost, yet so difficult to replace. Holds in place quite decently courtesy of a pair of nubs on either side, and doesn't slide out easily as a result. Pops out using a fingernail and just a little bit of force. Also has a little arrow indent inside for the sake of my personal OCD. Should print perfectly fine using normal or higher resolution - biggest concern with lower resolution would be the nubs. The model is upside-down, so make sure you flip it before slicing and printing. Note: I used an FZ-JP1X for reference and fitment.
Statistics
Likes
0
Downloads
0