4010 Blower Fan Mount for Mellanox ConnectX-2
Description
Mellanox ConnextX-2 10G NIC runs hot without airflow. I designed this mount so the card can be used in a single slot environment. To use this mount, you need to solder 2 wires to the 12V and GND test points. See photos to locate them on the PCB. The mount may interfere with the PCIE X16 clip. I removed it on my machine. For mounting you need some M2 screws. Lower right hole lining up with the hold in the PCB. 1x M2*12mm 1x M2 washer 1x M2 nut Upper right: 1x M2*6mm Left: 2x M2*3mm PLA will work, but it is recommended to use higher temp materials.
Statistics
Likes
0
Downloads
0