Nerf Kronomag conversion
Description
Link to images: https://imgur.com/a/nq9uyND Different models for Talon vs Katana and 16mm barrel vs 17/32 brass For the 3D printed pusher you will need a 012 O ring (common pusher O ring) For the brass barrel and pusher you will need a length of 17/32 brass (I used 10 inches but) and 90mm of 1/2 in brass for the pusher. For the pusher, cut 12 small lines in the end (about 5mm) and gently roll the end over to create a taper to push the darts. I also glued my barrel into the front of the adapter with some epoxy. For the ram base I put a single wrap of electrical tape around the outside to get a good air seal into the plunger tube and make sure it wouldn't come out. The cutting template is the same for both the talon or katana adapter. Center on the blaster and trace the inside. In most places there is about 2mm worth of margin. If you have any questions feel free to comment and ask. For the mag release lever you need to reuse one of the springs out of the blaster off of one of the locks. If you want to keep all of the locks then there are other springs used in the rival round chambering mechanism where the lips move to allow a round to be inserted. I have only tested this with a talon magazine and the brass barrel and pusher. If any changes need to be made to the katana adapter or the 16mm versions let me know. The magazine release back plate attaches with the same screw the release lever pivots on. If anyone is curios about what FPS you could expect out of one of these, I am getting about 210-220 with the red adventure force darts and a K25 through a 10 in brass barrel. Credit to Flygonial and the Gryphon blaster for the mag release lever, I modified it a little but the release lever was his design.
Statistics
Likes
0
Downloads
0