Chimera 7 Pro V2 Wire Protection Shoulder Pads
Description
This is designed for the Chimera 7 Pro V2, however it “may” fit the Chimera 7 Pro or Chimera 7 (no guarantees). TPU not recommended since it is a snap fit, and harder plastics are better at deflecting the prop without breaking it anyways. The fit is snug, and the internal geometry is supported all along the carbon arm on the sides of the motor wires. Standard version is for use with the factory motor wire tape strip in place, the _NoTape version is for use without the factory tape. May not fit depending on how your drone came from iFlight, but I did give it a bit of room inside to account for some variance. Let me know if you need this slightly modified though, and I should be able to make a custom version for you.
Statistics
Likes
0
Downloads
0