iPad & Macbook Air Stand
Description
We did use another dual stand that I found here for a while but found it too instable so I decided do quickly do my own. It's very simple and measured 9mm (3/8Inch) width for the iPad slot and 17.5mm (11/16 Inch) width for the Macbook Air slot. Prints without supports obviously. Don't mind the slight warp on the left side in my pictures, I messed up the print with an uncleaned printbed. It will print fine and flat if you don't screw up as I did ;) That will also improve the quality of the curved surface on that side. The stand does it's job nicely as I printed it, so won't print again (it has it's place on the top shelf of a kitchen rack, so is hardly seen anyway). However, if I was to print again, I'd go for 0.15mm quality and activate ironing to get a slightly smoother surface throughout.
Statistics
Likes
0
Downloads
1