Ender 5 Plus BTT PI TFT70 V2 Case
Description
This is a case designed for use with the factory OEM Ender 5 Plus frame and electronics enclosure. It will hold a BigTreeTech (BTT) PI TFT70 touchscreen for use with Klipperscreen or Octoscreen. This is not designed for the Raspberry Pi to be directly mounted to the screen. I have my Pi mounted elsewhere in the electronics enclosure, however there should be enough clearance in the factory case opening to allow for the Pi to be mounted. A remix may be required to align the screen with the factory opening a little better. Check your print tolerances! There are delicate ribbon cables on the bottom edge of the TFT70 screen. These should fit snug and the screen should fit in place without very much force. You may need to apply a small amount of force to get the screen standoffs to pop into the holes in the case. Use M2.5 hex-head bolts to secure the screen in place. Use M3 hex-head bolts and t-nuts to secure the case to the v-slot frame.
Statistics
Likes
0
Downloads
0