Bathroom Corner Shelf - 7 inch radius
Description
Simple corner shelf I made for my bathroom since I couldn't find anything on here that would work. I secured it with screws and it holds my phone, book, and cup of coffee at once just fine. The chamfer is 7/8 inch in to fit over the corner trim. Printed with PLA at 15% infill, top side down for a nice smooth finish. I printed the one with holes but I uploaded it with and without them. I made the screw holes .15 inches knowing I would have to drill them out to match my screws but the solid wall made that easy. Unfortunately command strips don't stick to PLA so screws are the only way unless you use command strip hooks. Hope someone else can make use of this! PLA 15% Infill Hot End 205C Bed 60C (heated bed highly recommended) 0.2mm layer height Retraction enabled No supports need, print with the top down.
Statistics
Likes
0
Downloads
0