DaVinci 1.0 Tilted 50mm Fan Clip-On Curved Front Duct with Support
Description
After Using My Previous Duct (Http://Www.Thingiverse.Com/Thing:785491) I Saw Significant Improvement On My Pla Prints. However, I Was Still Unsatisfied. I Still Saw Occasional Spots That Could Have Been Avoided With More Air Flow. Also, When I Put My Hand Over The Back Side Of The Fan, I Felt Air Coming Out. That'S When I Decided To Change The Design A Bit To Maximize The Airflow To The Extruder. 1. I Tilted The Fan To Point It More Towards The Right Direction. 2. I Curved The Duct To Better Facilitate Air Direction. Happy To Say The Result Is Significantly Better Than The Previous Duct. Like The Previous, This Is Designed With Supports In Place. Just Slice And Print.
Statistics
Likes
71
Downloads
0