BN-880 mount for CRUX35 - Remix
Description
My first remix! Made in Tinkercad. Wanted a simple mounting option to put a BN-880 GPS/Compass on a Crux35. Every available model was for smaller GPS units. It has just enough clearance for a Runcam Thump Pro in its stock mount. Secure with a zip tie. Adding a bit of foam double sided tape or even foam rubber between the mount and the top plate of the drone is recommended, but not required. I will most likely make a V3 (V1 was a failure) to optimize camera adjustment room soon. The position it is in now is about what I use anyway, but I know some people will want some more tilt. My goal is to allow for up to 30 degrees of adjustment. If you need any other additional tweaks feel free to leave them in the comments. I can try to accommodate you're requests to the best of my ability. I have not had a chance to make sure it gets a good GPS link while so close to the camera (Lots of snow at the moment). If you give it a try yourself please let me know how it goes. Please do not depend or even try return to home until you have insured that GPS works well in your use-case. The CRUX35 mounting part is from mmh2022 and the BN-880 GPS mount is from SECOUM. You will also need to print the cover from the original GPS mount. That file can be found on the [original models page](https://www.thingiverse.com/thing:3635443) made by SECOUM. You will need the BN880_SUP.stl file.
Statistics
Likes
0
Downloads
0