Filament Sensor Bowden Feed Bracket - Any Cubic Kobra Vyper
Description
This little bracket is for mounting a bowden tube to the filament sensor for an external dryer or when you have a cabinet and would like to have the roll outside the cabinet. STL has a M6 x 1.0 thread pitch for the PTC (Push To Connect) connector. You will probably need to tap this out if printing on a FLA printer. You can also drill and tap this out for other thread sizes of PTC connectors. You will need a M3 x 0.5 x 25mm long bolt to mount this to. (I used a slightly longer bolt for mockup and photos) After you mount this, just attach any length bowden tube and you can remotely run your dryer anywhere you would like. Bolts can be purchased on Amazon here: https://www.amazon.com/dp/B07WZN3Q98 PTC can be purchased on Amazon here: https://www.amazon.com/dp/B01NANKRTD Additional bowden tube can be purchased on Amazon here: https://www.amazon.com/dp/B073RDFTDV
Statistics
Likes
0
Downloads
0