Z bearing synchronous adjuster (Sovol SV04)
Description
On some 3D printers there is a cheap solution to set Z bearing tigtness which doesn't care about keep mechanics square/paralell, and gives unadequate control to all bearings on gantry. If we put eccentric screws to bots side of bearing, there is a lack of synchronisation between eccentric columns. This concept connects screws to set these together. It is required to drill both side of gantry up to 7mm to accept eccentric part of screw. This design is a concept, not installed yet, USE AT YOUR OWN RISK !
Statistics
Likes
0
Downloads
0