Hemera_xs_fan_shroud_extra_support
Description
A remix of a fan shroud for the Hemera (XS). The issue I had was the shroud started to sag due to the weight and heat. So I added extra support to stabilise the fan. This enabled an extra mounting point for the fan itself. I removed the chamfer for the Hemera mounting holes, due to the small tolerances of the Hemera mounting point. A small bolt with a washer works well, and so far I didn't have to re-tighten the screws. I used it for my Sidewinder X1 upgrade, but the design can be used for any printer. The Shroud can be printed with minimal supports. Final print I used ASA printed at 250 degrees Bed heated to 90 degrees Support only over 65 degrees angles
Statistics
Likes
0
Downloads
0