TECH8 USA Mouse Mover & Jiggler Platform Expander
Description
My mouse was too large to fit on the TECH8 USA Mouse Mover, so I created a platform extender to support larger mice. The product can be found at this link: [https://www.amazon.com/dp/B08THDGY5Y](https://www.amazon.com/dp/B08THDGY5Y). Before:  Start by printing either "mouse-mover-platform.stl" or "mouse-mover-platform-mx.stl" (if you have an original Logitech MX Master mouse and want to use that specific platform), and then place it on your TECH8 USA Mouse Mover.  Next, print "mouse-mover-platform-spacer.stl" and place it in the hole of the platform.  Next, print "mouse-mover-platform-disc.stl" and apply a small amount of double-sided tape to the bottom. Be careful not to apply too much as it may be difficult to remove if necessary.  Set the disc, tape-side down, onto the mouse mover with the spacer in place and push down to adhere the tape.  Remove the spacer and admire the final product.   And with the Logitech MX Master platform option.  
Statistics
Likes
0
Downloads
0