Butane Torch Base
Description
Needed a replacement base for my butane torch, but could not find a suitable one (or one that would fit) my "Scorch Torch". The torch is just under 52mm wide at the lip found at the bottom of the torch. So I designed this base to be as SNUG as possible with a recessed ring around the bottom of the inside so that the lip of the torch can slip into that to hold on better. I have printed this base with and without supports, and the inner/recessed ring does print better with supports enabled. But despite a few loose strands, it prints just fine without supports!
Statistics
Likes
0
Downloads
0