Lamp Shade 089
Description
There are a lot of great lamp shades out there to print, thought I'd give it a try. It's just a small difference from the flower and pencil vases I do. This is a twisty, crisscross table lamp shade to give soft light on a desk or in the corner of your room. There are no wires to cut, splice or solder together to make a base. It is designed to fit on a 4 inch/10cm led display base. The printed shade sits on top of the base, it is not attached. I used a colored led base from Amazon here: https://www.amazon.com/dp/B08YYTGX2H?psc=1&ref=ppx_yo2ov_dt_b_product_details Or a white one here: https://www.amazon.com/dp/B08Y5GCPTC?ref=ppx_yo2ov_dt_b_product_details&th=1 The lamp shade should be printed without a top or a bottom. The stl file is solid with a top and bottom so be sure and put 0 bottom layers and 0 top layers in your slicer. The vase in the photos is printed in vase mode and has not been scaled and is printed at 100% of the stl file. The x and y axis shows 116mm wide and z is 160mm tall. It can be printed in any color of pla. A lighter color will let light shine through better and show off the design better. The photos show the vase printed in white by Tecbear. The lamp shade can be printed in spiral vase mode or can be printed in normal mode by unchecking vase mode, set walls to 1 and 0 top layers, 0 bottom layers and 0% infill. A brim is recommended, as a single wall on the lamp will have difficulty sticking to the print bed. All my designs have a copyright, you may not download and sell them. Tips are appreciated! Enjoy...
Statistics
Likes
0
Downloads
1