Bluetooth BT5.0 Audio Pro receiver case enclosure
Description
Case for Bluetooth BT5.0 Pro receiver. Recheck the size and picture of your receiver. There are many models. You will need to print 3 buttons and provide, at least, one m2 10mm screw to close the case. Notice that tolerances are rather tight. No supports are needed. Be careful when inserting the board into the case. First place the board inside and then slide it a little bit towards the side where the USB and audio jack is placed. Board buttons should tightly fit behind the printed buttons. **Do not force anything** otherwise you may break a board button.
Statistics
Likes
0
Downloads
3