DoctorHogmaster high pin count pinning tray and gutting station V1.1
Description
This gutting station was inspired by Tvirelli's Toool gutting station https://www.thingiverse.com/thing:3301246 This is a pining tray and gutting station specifically designed for high pin count (HPC) locks, or locks with a lot of locking features like pins and sliders. It also works well to keep track of multiple rows of pins for locks as is common with high pin count locks. Of course, it should work with lower pin count locks as well, but there are a lot of great options for those and I found few that would work for locks with 20 or more locking features. There are 60 slots separated into 6 sections in the bottom of the tray for either individual pins / sliders / springs, or whole pin stacks depending on what is needed based on number of locking devices and number of rows. There are 2 spots for sidebars and 2 springs each. There's a spot to hold a plug, and a small square spot for retaining clips. there are a few round slots intended for common sizes of round followers. Slots for tweezers or other tools, slots for shims, and some extras for whatever somebody might find handy to have when gutting. V1.1 increased the size of the follower holes to ensure to extra work is required for most common follower sizes to fit easily in and out. The original was too precise and followers would gut stuck on an air cushion when going in, and pull the tray up with suction coming out.
Statistics
Likes
0
Downloads
1