Radxa Taco NAS case
Description
Fits the Radxa Taco board and 80mm PC fan with up to 5x 15mm HDDs Requires: 80mm PC fan and screws - I used Arctic Temperature Controlled. M2 hex bolts and heat set nuts - for Taco board M3 hex bolts and heat set nuts - for all other fixings Assembly: Fix CM4 module and heat sink to Taco board. Attach Taco Board to 'Lid' Attach HDD's/SSD's Attach HDD/SSD feet Attach Fan to base. Plug fan into 12v ATX pin Fit base over HDD's Screw HDD caddy feet into base - check orientation! Fix 'base' to 'lid' Everything prints flat without supports. No particular print settings required, just use common sense. I used translucent PLA to see the HDD activity lights through the case.
Statistics
Likes
0
Downloads
0