Simple Dpad
Description
A simple dpad made for arduino/pi/whatever . Designed to be printed and used with below BOM. BOM/ What you need - A 3d printer (obviously) - This board https://www.amazon.com/DIKAVS-25-4x25-4mm-Perforated-Protoboard-Solderable/dp/B09ZPFPJGL/ref=sr_1_5?crid=X3YRNNL2SC2Z&keywords=1+inch+perf+board&qid=1675715545&sprefix=1+inch+perf+board%2Caps%2C268&sr=8-5 - 5 mm push buttons. 4 of em - solder skills - some wires. Instructions - put push buttons as pictured in thing - solder small wires between ground pins on each button to form a "ground chain" - solder a wire to each pins positive pin. - solder a wire to last point in ground chain - this should give you 5 wires coming from board. - attach these to arduino/pi/whatever
Statistics
Likes
0
Downloads
1